Course Main Menu

Aside from the installation instructions not allowing it, now NEC 240.33 does not allow enclosures for overcurrent devices to be mounted other than vertical.

Low-voltage nonrenewable fuses shall not be permitted to be reconditioned. Is there anything wrong with this picture?

GE markets the High-Pressure Contact (HPC) switches as an arc flash hazard mitigation solution.

An instantaneous trip&nbsp;setting must be less than the available arcing current. A documented analysis can determine the arcing current.

The arc energy reduction protection system shall be performance tested by primary current injection testing or another approved method when first installed on site.

Molded-case circuit breakers shall not be permitted to be reconditioned.

Medium-voltage fuseholders and medium-voltage nonrenewable fuses shall not be permitted to be reconditioned.

Many line side connections terminate in an enclosure that is not considered a service disconnect.

NEC 250.28(A) now permits aluminum and copper-clad aluminum main bonding jumpers which aligns with Table 250.102(C)(1).

Multiple generators of the same type connected in parallel.

Relying on the rebar to interconnect the water pipe to the service as in the image is a code violation.

What type of PVC should be used to protect these grounding electrode conductors? Schedule 40 or schedule 80?

Cable armor is similar to armored cable type AC, but there is little space between the armor and the conductor inside.

The words &ldquo;service-entrance&rdquo; were removed from NEC Table 250.66.

The rebar stub up on the right emerged from the concrete stem wall, not the earth (soil). No additional corrosion protection required by code.

NEC Table 250.102(C)(1).

Metal enclosures are permitted to be used to connect bonding jumpers or equipment grounding conductors, or both, together to become a part of an effective ground-fault current path.

An equipment grounding conductor passing through the box without a splice is not required to be joined inside the box to others that are spliced in the box.

Connections, taps, or extensions made from paralleled conductors shall connect to all conductors of the paralleled set.

There are many listed transition fittings that serve as an extension of a raceway or other wiring method.